Page 1 of 1

Spanner Wrench for Fan Hub

PostPosted: Thu Dec 13, 2007 1:03 pm
by cbergen
This tool makes installing and removing the fan and hub from your Gasser/90 engine much easier.

Image

#1003T 10.95, including 2 4X16 SHCS

The entire toolkit is available, #TOOLKIT, $24.95. Includes all 3 tools.

Use it to hold the fan hub while tightening the bolt in the gas engine, or the collet nut on the Nitro engines.

Image

Especially useful for the 90's where you REALLY need to torque that nut to prevent it coming loose, and on the gas engine to prevent "twisting" the crank while using a piston lock or some other method holding the flywheel, neither of which are recommended procedures.