Industrial Turbine Specs

Everything related to the Industrial Turbine Helicopter

Industrial Turbine Specs

Postby cbergen » Tue Jan 16, 2007 8:27 am

INDUSTRIAL TURBINE SPECIFICATIONS
NOVEMBER 2006

Length: 59" Height: 22" Weight: 18 lbs. Fuel Tanks: Dual 33 oz.

Main Blades: 810mm V-Blades(Included) Tail Blades: 130mm(included)

Engine: Wren MW 54 2 stage system

Gear Ratio 9:1:4.67 other ratios available upon request.

The Bergen R/C Industrial Turbine is a workhorse capable of lifting up to a 25 lb. payload or fly for appx one half hour on a full load of fuel. Flight times will be reduced, the heavier the payload. Additional fuel can be added for longer flight times.

The Industrial Turbine uses a Wren MW 54 turbine engine, producing approximately 8 horsepower, manufactured by Wren Turbines of England. This is a 2-stage system, giving increased fuel economy and power.

Power is transmitted through a heavy-duty double clutch and clutch bell to a double main gear. A fully hardened 10mm hollow main shaft turns the all aluminum head and fully ball raced aluminum blade grips. Symmetrical 810mm V-Blades are included to provide the lifting power. MAH Hi-lift 890mm blades can be substituted for increased lifting capacity.

The Industrial Turbine features an aluminum torque tube to transmit power to the Heavy Duty aluminum tail gearbox with Delrin gears and 130 mm tail blades.

The landing gear is doubled to handle the weight of the helicopter, and 1/8th G10 frames provide the strength to hold it all together.

The Industrial Turbine comes pre-assembled and test flown from the factory. Only minor assembly is necessary after you receive the helicopter. We will install and use your radio gear for the test flights.

Image
Chris Bergen
Bergen R/C Helicopters
cbergen
 
Posts: 126
Joined: Thu Jan 11, 2007 8:15 pm
Location: Cassopolis, MI

Return to Industrial Turbine

Who is online

Users browsing this forum: No registered users and 1 guest

cron